NetComm NP2724M - Manual (Page 41)

Mode Interface Config
qos
This command specifies port-based qos.
Format qos port-based status {enable | disable}
Mode Interface Config
rate-limit
1) rate-limit egress
This command limits egress rate, which the unit is Kbps.
Format rate-limit egress <rate>
Mode Interface Config
2) rate-limit ingress
This command limits ingress rate, which the unit is Kbps.
Format rate-limit ingress <rate>
Mode Interface Config
storm-control
1) Enable/disable storm control.
Format storm-control {enable | disable}
Mode Interface Config
2) storm-control broadcast
This command storm control for broadcast only, and limited
value :0,64,256,1024,10240,65536.102400,1024000,which the unit is Kbps
and 0 means no limit.
Format storm-control broadcast <rate>
Mode Interface Config
3) storm-control broadcast-multicast
This command storm control limited
value :0,64,256,1024,10240,65536.102400,1024000,which the unit is Kbps
and 0 means no limit.
Format storm-control broadcast-multicast <rate>
Mode Interface Config
4) storm-control broadcast-unknown
This command storm control limited
value :0,64,256,1024,10240,65536.102400,1024000,which the unit is Kbps
and 0 means no limit.
Format storm-control broadcast-unknown <rate>
Mode Interface Config
e.g. Switch(Interface 1)# storm-control broadcast-unknown 64
5) storm-control all-cast
This command storm control limited
value :0,64,256,1024,10240,65536.102400,1024000,which the unit is Kbps
and 0 means no limit.
Format storm-control all-cast <rate>
Mode Interface Config
rmon-counter
This command specifies rmon counter capability on a port
Format rmon-counter {enable | disable}
NP2724M User Manual 40