NetComm NP2724M - Manual (Page 35)

This command creates a MST instance.
Format spanning-tree mst vlan <MST ID> <vlan list> add
Mode Global Config
e.g. Switch(Config)# Spanning-Tree mst vlan 3 3-5 add
8.2.2) Spanning-Tree mst vlan <MST ID> <vlan list> delete
This command deletes a vlan from a MST instance.
Format Spanning-Tree mst vlan <MST ID> < vlan list> delete
Mode Global Config
8.3) spanning-tree mst bridgepri
This command configures bridge priority for a MST instance.
Format spanning-tree mst bridgepri <MST ID> <priority>
Mode Global Config
8.4) spanning-tree mst cost
This command configures port path cost in a MST instance.
Format spanning-tree mst cost <MST ID> <path cost> ports <port list>
Mode Global Config
8.5) spanning-tree mst priority
This command configures port priority in a MST instance
Format spanning-tree mst priority <MST ID> <priority> ports <port list>
Mode Global Config
User
This command changes user password.
Format user password
Mode Global Config
Interface
This command enters into configure interface mode.
Format Interface <port-ID>
Mode Global Config
rmon
This command is used to configure RMON.
1) rmon event
This command creates rmon event entry.
Format rmon event index < 1..65535 > desc <WORD> event <1..4>
community <WORD>owner<WORD>
Mode Global Config
e.g. Switch(Config)# rmon event index 1 desc 123 event 4 community 123
owner test
2) rmon alarm
This command creates rmon alarm entry.
Format rmon alarm index < 1..65535 >interval<0..3600>interface<port
number>counter<1..17>sample{absolute|delta}start{rasing|falling|all}rthresh
old<0..65535>fthreshold<0..65535> reindex <0..65535> feindex<0..65535>
owner< WORD>
Mode Global Config
e.g. Switch(Config)# RMON alarm index 1 interval 10 interface counter 1
sample delta start all rthreshold 100 fthreshold 10 reindex 1 feindex 0
owner test
3) rmon del
NP2724M User Manual 34