NEC AT-35 - Manual (Page 9)

INITIAL SETUP
Selecting the Dialling Mode
Set the dialling mode switch to either DP (Pulse) or MF (Tone) to select the
signalling type. The correct mode depends on the requirements of the
PBX to which the telephone is connected.
Setting the LCD Contrast
There are 5 display contrast settings.
1. Ensure the phone is idle.
2. Press VOLUME repeatedly to
set the desired LCD contrast.
Selecting the Ringing Volume
Select from three ringing volume levels using the Ringing Volume Switch,
L (low), M (mid), or H (high).
Selecting the Ringing Tone
There are 3 ringing tones to choose from – low, mid and high pitch.
1. Ensure the phone is idle.
2. Dial
¿ 1 ¿.
3. Dial 1 (low), 2 (mid) or 3 (high). (Default setting is 1.)
4. Dial #.
The selected ringing tone will play for approximately 2 seconds.
Setting the Clock
This telephone is equipped with a 24 hour clock. The clock is shown on
the display while the phone is idle. To set the clock, follow the steps below.
1. Ensure the phone is idle.
2. Hold the SET TIME button for approx. 2 seconds until the year appears
flashing on the display.
3. Advance up or down to the correct year by pressing the or keys.
4. Press the SET TIME button to set the year and advance to the Month.
5. Repeat this process to set the Month, Date, Hour and Minute.
8