Newcon Optik LAM 10M IR - Manual (Page 13)

10
5. OPERATION INSTRUCTIONS
5.1. Installing the battery
LAM is powered by a standard Lithium CR123 3V battery.
To install a battery:
-
unscrew the battery compartment cap (15, Fig.1),
- insert a battery observing the polarity as marked on the
battery compartment,
- check the condition of the O-ring on the body; replace it
if worn or torn,
- screw the battery compartment cap back on.
5.2. Mounting LAM on a weapon
LAM is mounted on a Picatinny rail in the following order:
-
loosen screw caps (13, Fig.1),
- align LAM on Picatinny rail,
- fasten the screw caps (13, Fig.1).
Note: The distance between the gas exit nozzles of the rifle
and laser beam output window should be as long as possible
so that the window would remain clean during shooting.