Nikon Coolpix P90 - Manual (Page 46)

34
Using the Flash
B
a
sic
Ph
ot
og
raph
y
an
d
Pl
ay
back
: A
u
to
Mode
B
Shooting When Lighting is Poor and When the Flash is Disabled (W)
• Use of a tripod is recommended to stabilize the camera during shooting and avoid the effects of
camera shake. Set Vibration reduction ( A143) to Off when using a tripod to stabilize the
camera during shooting.
• The E indicator is displayed when the camera automatically increases sensitivity. Pictures taken
when E is displayed may be slightly mottled.
B
Note on Using the Flash
When using the flash, reflections from dust particles in the air may appear as bright spots in pictures. To
reduce these reflections, set the flash mode to W (Off ), or shoot pictures with the built-in flash lowered.
C
The Flash Indicator
The flash indicator shows the flash status when the shutter-release
button is pressed halfway down.
• On:
Flash will fire when picture is shot.
• Blinks: Flash is charging. Wait a few seconds and try again.
• Off:
Flash will not fire when picture is shot.
C
The Flash Mode Setting
• The default flash mode setting varies with shooting mode.
- A (auto) mode: U (auto)
-
A, B, C, D mode: U (auto)
- Scene mode: setting varies for different scene modes ( A41 to 47).
- x (scene auto selector) mode: U (auto) the camera automatically chooses the optimum
flash mode setting for the scene mode it has selected ( A32).
- d (sport continuous) mode: W (off )
- Time-lapse movie: U (Auto)
• The flash mode setting V (auto with red-eye reduction) applied in A (auto) mode is stored in
the camera’s memory even after the camera is turned off, and reapplied the next time A (auto)
mode is selected.
• For A, B, C and D shooting modes, the setting for flash mode will be stored in the camera’s
memory even after the camera is turned off.
C
Red-eye Reduction
This camera uses Advanced Red-eye Reduction (“In-Camera Red-Eye Fix”).
The flash fires repeatedly at low intensity before the main flash, reducing the red-eye effect.
The camera then analyzes the picture; if red-eye is detected, the affected area will be processed to
further reduce red-eye before the picture is saved.
Note that because there is a slight lag between the shutter-release button being pressed and the
picture being shot, this mode is not recommended when a quick shutter response is required. The
time before the next picture can be shot also increases slightly. Advanced red-eye reduction may not
produce the desired results in all situations. In extremely rare instances, areas not subject to red-eye
may be affected by advanced red-eye reduction processing; in these cases, choose another mode
and try again.