NEC LT155 - Manual (Page 18)

E – 18
PC CONTROL
VIDEO S-VIDEO RGB AUDIO
Wiring Diagram
RGB Signal cable (supplied)
To mini D-Sub 15-pin connector on the pro-
jector. It is recommended that you use a
commercially available distribution amplifier
if connecting a signal cable longer than the
supplied one.
IBM VGA or Compatibles
(Desktop type or notebook type)
DVD Player (with component output)
Document Camera
Optional Component
V cable
To video, S-video, and audio
inputs on the projector.
VCR, DVD Player or
LaserDisc Player
Macintosh or Compatibles
(Desktop type or notebook type)
NOTE: When using with a notebook PC, be sure to connect between the projector and the notebook PC before turning on the power to the notebook PC. In most cases
signal cannot be output from RGB output unless the notebook PC is turned on after connecting with the projector.
NOTE:
* If the screen goes blank while using your remote control, it may be the result of the computer’s screen-saver or power management software.
* If you accidentally hit the POWER button on the remote control, wait 60 seconds and then press the POWER button again to resume.
NOTE: If using video, S-video, or audio cables, the cables should be 3 m (9.8 feet) or shorter.