NEC LT155 - Manual (Page 24)

E – 24
3. OPERATION
Connecting the Power Cable and Turn on the
Projector
Before you turn on your projector, ensure that the computer or video
source is turned on and that your lens cap is removed.
1. Connect the supplied power cable to the projector.
ME NU
EN TE R
CA NC EL
SE LE CT
PO WE R
ST AT US
ON / ST AN D B Y
SO UR CE
AU TO AD JU ST
PC C AR D
AC CE SS
AC IN
C C AR D
US B
PC C ON TR OL
VID EO
S-V ID EO
RG B
AU DIO
Plug the supplied power cable in the wall outlet. The projector will
go into its standby mode and the power indicator will glow orange.
2. Turn on and off the Projector
VIDEO S-VIDEO AUTO ADJ.
RGB 1
MENU LASER
RGB 2 PJ
ON OFF
Power ON button
ME
N
E NTER
CA
NC
EL
SELECT
POWER
STATUS
ON
/
STAND BY
SOURCE
AUTO
ADJUST
PC CARD
ACCESS
PC
C ON
TR
OL VID
EO
S-V
ID EO
Power ON/STAND BY button
Indicator
To turn on the projector:
Only after you press the “On” button on the remote control (“ON/
STAND BY” button on the projector cabinet) will the power indicator
turn to green and the projector become ready to use.
NOTE: To turn the projector on by plugging in the power cable, use the
menu and enable the “Auto Start” feature. (See page E-38.)
NOTE: Immediately after turning on the projector, screen flicker may occur.
This is not a fault. Wait 3 to 5 minutes until the lamp lighting is stabilized.
To turn off the projector:
First press the “off” button on the remote control (“ON/STAND BY”
button on the projector cabinet) for a minimum of two seconds. The
power indicator will glow orange. After the projector turns off, the
cooling fans keep operating for one minute.
NOTE: Do not disconnect the power cable during this time. Then, unplug
the power cable. The power indicator will go out.
Status of indicator light: turn on
POWER
STATUS
POWER
STATUS
ON/
STAND BY
POWER
STATUS
High-Bright mode:
stand by
steady orange light
flashing green light steady green light
flashing one minute steady light
Eco mode:
POWER
STATUS
POWER
STATUS
POWER
STATUS ON/
STAND BY
stand by
steady orange light
flashing green light
(High-Bright mode) steady green light
(Eco mode)
flashing one minute steady light
Status of indicator light: turn off
ON/
STAND BY
POWER
STATUS
POWER
STATUS
POWER
STATUS
ON
steady green light
change to flashing
green light steady orange light
cooling down stand by
Press a minimum
of two seconds.