Connecting your pc, E – 19, Ue nter – NEC LT155 User Manual
Page 19
E – 19
ME
N
U
E
NTER
CA
NC
EL
SELECT
POWER
STATUS
ON
/
STAND BY
SOURCE
AUTO
ADJUST
PC CARD
ACCESS
AC IN
C C
AR
D
PC
C
ON
TR
OL VID
EO
RG
B
US
B
S-
VID
EO
AU
DIO
RGB
S-VIDEO
AUDIO
DEO
RGB INPUT
AUDIO
IBM VGA or Compatibles (Notebook type)
IBM VGA or Compatibles (Desktop type)
Audio cable (not supplied)
Connecting Your PC
Connecting your PC to your MultiSync LT155 (XGA)/ LT154 (XGA)
projector will enable you to project your computer’s screen image for
an impressive presentation.
To connect to a PC, simply:
1. Turn off the power to your projector and computer.
2. Use the supplied signal cable to connect your PC to the projector.
3. Turn on the projector and the computer.
4. If the projector goes blank after a period of inactivity, it may be caused
by a screen saver installed on the computer you’ve connected to the
projector.
RGB signal cable (supplied)
To mini D-Sub 15-pin connector on the projector. It is
recommended that you use a commercially available
distribution amplifier if connecting a signal cable longer
than the supplied one.