Nikon VT695 - Manual (Page 27)

19
2. Installation and Connections
Connecting the Supplied Power Cable
Connect the supplied power cable to the projector.
First connect the supplied power cable's two-pin plug to the AC IN of the projector, and then connect the other plug of
the supplied power cable in the wall outlet.
CAUTION:
Do not try to touch the ventilation outlet on the left front (when seen from the front) as it can become heated while
the projector is turned on and immediately after the projector is turned off.
CAUTION:
Do not turn off the AC power by pressing the main power switch or by unplugging the power cable when the
projector is powered on. Doing so can cause damage to the projector.
TIP: The projector can be turned off (by either the main power switch or by unplugging the power cable)
during its cool down period after it is turned off using the remote control or via the power button on the control panel.
FO CU S
ME NU
SEL ECT LAM P STA TUS POW ER
ON/S TAN D B Y SOU RCE
AUT O A DJ.
E N T ER
E X I T
ZO OM
Make sure that the prongs are fully inserted into both
the AC IN and the wall outlet.
To wall outlet ←