NEC TheaterSync Video Processor - Manual (Page 20)

MKT-0026-UMN-1.002F TheaterSync Video Processor User Manual
Table 2: TheaterSync Output Modes
Output Mode Comments
VGA 60 Hz (640 x 480) VESA Standard
VGA 50 Hz (640 x 480) VESA Standard
848 x 480 60 Hz /
SVGA 60 Hz (800 x 600) VESA Standard
SVGA 50 Hz (800 x 600) VESA Standard
720p 60 Hz (1280 x 720) SMPTE Standard
720p 50 Hz (1280 x 720) SMPTE Standard
XGA 72 Hz (1024 x 768) VESA Standard
XGA 60 Hz (1024 x 768) VESA Standard
XGA 50 Hz (1024 x 768) VESA Standard
1360 x 768 60 Hz /
1365 x 768 60 Hz /
1400 x 788 60 Hz /
SXGA 60 Hz (1280 x 1024) VESA Standard
SXGA 50 Hz (1280 x 1024) VESA Standard
SXGA+ 60 Hz (1400 x 1050) VESA Standard
SXGA+ 50 Hz (1400 x 1050) VESA Standard
1080p 60 Hz (1920 x 1080) SMPTE Standard
1080p 50 Hz (1920 x 1080) SMPTE Standard
1080p 48 Hz (1920 x 1080) SMPTE Standard
QXGA 60 Hz (2048 x 1536) /
QXGA 50 Hz (2048 x 1536) /
QXGA 48 Hz (2048 x 1536) /
On entry to setup mode, the 24 x 2 LCD display indicates the following:
THEATERSYNC
Setup
Select the Menu key on your IR Remote to bring up the Setup Menu on the 24 x 2 LCD display.
The LCD display will indicate the following:
“Parameter” = ???
Setup Mode
Using the Up and Down navigation keys on the remote, you can select the next parameter in a
circular list of parameters. Using the Left and Right navigation keys on the remote, you can
select the value of the parameter. In some cases, the parameter is visible in the setup menu, but
may not be altered (such as Serial Number or MAC Address).
Selection of IP addresses is slightly different. IP addresses may only be selected if the DHCP
parameter has been set to “Off”. In this case, you use the Left or Right navigation key to “enter”
the IP address. The Left key will highlight the rightmost octet; the Right key will select the
Page 20 NEC Solutions, Inc.