NEC Xn120 Vision - Manual (Page 5)

4 7
Placing Calls If your call doesn’ t go through…
u Pressing CALL key after dialling an extension number is also possible.
u Your call will ring or voice-announce. If you hear ringing, wait for an answer. If you hear a beep, begin
speaking. Dialling “1” changes voice/ring mode (where the destination is an XN120 Telephone).
Placing an Intercom Call <Dial Access>
Extension Number
CALL
? ? ?
u Listen for Dial Tone before dialling the Telephone Number.
Placing an Outside Call <Access Code>
CALL Telephone Number
? ? ? ? 9
Trunk Code
u Listen for Dial Tone before dialling a Telephone Number.
u You can have function keys for Trunks or Trunk Groups. Ask your Supplier.
Placing an Outside Call <Quick Access>
Trunk Key
Telephone Number
? ? ? ?
Repeat Dialling <Outside Call>
u The system periodically redials the call. Repeat duration is programmable. Ask your NEC Authorised
Supplier for details.
u You should lift the handset when the called party answered.
u You can cancel this function by pressing “DC” and “LND” during idle condition.
u Does not reserve line. Will select other available line when original line is in use.
Checking & Answering a Message Waiting Indication
CHECK
(On-Hook)
VOL
(Check Name)
You can check who left a message waiting indication for you, and then answer.
8 1 4
u Applicable to XN120 Vision Telephones only.
3
Clearing All Message Waiting Indications (at any extension)
CALL
8 7
SPK
u Clears all messages you have left for other extensions and messages other extension have left for you.
(Hear Busy Tone
or No answer)
DC LND
Repeat Dial Key
(SC.851+29)
[Flashes red when set.]
[Press flashing key to cancel.]
Cancelling a Message Waiting Indication (at originating extension)
CALL
8 7
SPK
1
Extension Number
you want to cancel MW
? ? ?