Nokia Mediamaster 9802 S - Manual (Page 36)

GB 36
MAIN MENU
View attributes
Chech position and orientation for different satellites by select-
ing the line “View attributes”.
When your antenna is controlled by a motor:
• Enter the “Channel search” menu.
• Select “Manual” or “Advanced” search.
• Select the new satellite name.
• Enter the settings for Transponder frequency, Polarization etc.
for the new satellite.
• Select the last line, “Adjust motor”, from where you now, by
pressing the buttons on the remote control, can move the an-
tenna to the position for the new satellite.
Watch the Signal strength (AGC) and Signal quality (SNR) bar
indications to check the levels. Please note: In this case,
(a brand-new satellite), you do not get a TV picture in the back-
ground on the screen, even when the SNR indication is good!
When both indication bars (AGC and SNR) are good:
• Press OK to start the channel search procedure in order to
download channels from the new satellite.
• When you get the message on the screen that ”you have
found X new TV-channels and X new radio channels”, press
OK to save the new channels.
If any new channels are found, they will be saved in the channel
list they belong to.
The position of the new satellite will be added to the prepro-
grammed satellite positions in the antenna motor.
Delete satellite
You can also delete an added satellite. (This is not possible for the
factory preprogrammed satellites.)
If you want to delete the satellite from which you right now are
watching a channel, you will get a screen message about how
to proceed.
When you delete a satellite you also delete its channels from the
channel lists.