NuTone Video Door Answering System VSUC4RK - Manual (Page 13)

3. Separate and strip approx. 1/2" of insulation from each of the eight wires in the cable. Twist the following cables
together:
• OR and OR/WH
• GR and GR/WH
• BL and BL/WH
• BR and BR/WH
4. Attach each of the twisted pair of wires to the corresponding terminal on the back of the camera. Tighten each screw
securely.
5. Dress extra cable and position camera into rough-in.
6. Fully seat the camera into the rough-in. Open the upper and lower access doors. Attach the camera to the rough-in
using a #6 x 1 3/4" screw (supplied) and flat washer (supplied) at both the top and bottom of the camera. Level the
camera, tighten screws and close upper and lower access doors the master station panel faced down to connect
wiring.
Important: If camera is exposed to outside elements, caulk should be added to the top and sides of the camera at
the wall surface. Do not caulk bottom surface.
13
Mounting Screw
and flat washer