NuTone Video Door Answering System VSUC4RK - Manual (Page 15)

Wiring and Mounting the TV/Monitor
Locate the TV/Monitor unit where the camera, TV, AM, FM and Telephone cables were previously ran. Depending on
the depth of the cabinet, decide if you need to make all the connections to the back of the TV/Monitor before fastening
the TV/Monitor to the bottom of the cabinet. The method and type of mounting hardware using to attaching the
TV/Monitor will very depending on your installation. Decide which mounting hardware to use based on the following
instructions.
Using #8 wood screws
• From underneath the cabinet, position the mounting hole template and mark the mounting hole locations.
• From underneath the cabinet, drill a 3/32" hole at each of the marked mounting hole locations (do not drill complete
thru into the inside of the cabinet).
• Measure the distance between the frame of the cabinet and the bottom of the cabinet. Combine the supplied 1/4",
1/2" and 3/4" round plastic spacers so they will fill the space between the bottom of the cabinet and the frame of
the cabinet.
• Depending on the depth of the cabinet, decide if you need to make all the connections to the back of the
TV/Monitor before fastening the TV/Monitor to the bottom of the cabinet.
• Position the round plastic spacer at each mounting hole location. To help hold the spacers in-place, position the
small diameter end of the spacer towards the TV/Monitor case. Lift and hold the TV/Monitor in position. Select a
7/8", 1 1/4", or 1 1/2" mounting screw (supplied) based on your particular installation and insert the first mounting
screw into one of the mounting holes in the TV/Monitor, and tighten.
15