NuTone Video Door Answering System VSUC4RK - Manual (Page 7)

Note to Installer: Do not discard these installation instructions. Please give all installation
instructions, warranty registration and homeowner’s manual to homeowner.
PRECAUTIONS AND GUIDELINES
The NuTone VSUC4RK has been designed for ease of installation. Please read and follow ALL installation instructions,
guidelines and precautions. Any deviation from these instructions or miswiring combinations will cause the unit to fail and
all NuTone warranties will be void.
WARNING: 120 Volt AC power to the VSUC4RK TV/Monitor must remain unplugged
until all system wiring at the TV/Monitor and camera is complete.
• Observe all local regulations and codes in your area.
• All screw terminals at the camera and TV/Monitor must be secure.
• Observe all color codes of wires when connecting camera to TV/Monitor.
• The VSUC4RK and camera is designed to be used with category 5 or category 6; no other cable should be used.
The use of wire other than category 5 or category 6 cable will void all NuTone warranties and may result in
faulty installation and improper operation.
• The door camera must not be mounted in an area that would be subject to direct sunlight or a strong reflec-
tion from the sun.
Wiring Specifications
The following cables must be installed to complete the installation. Depending on the type of installation, these cables
may be installed during framing (new construction) or in an existing home. For new construction it is important to deter-
mine the final location of the TV/Monitor and Camera so all needed cables can be ran before finished walls are installed.
An existing home will require cables to be “fished” to the TV/Monitor and camera locations.
• Use category 5 or category 6 cable for connecting:
• VSC4R camera to TV/Monitor: 250 ft maximum
• Optional second camera to TV/Monitor (NuTone Models VSC4R and VSC4S): 250 ft maximum
• Use the supplied AM antenna to connect to the AM antenna terminals on the TV/Monitor.
• Use either of the supplied FM antennas to connect to the FM antenna on the TV/Monitor. An optional (not supplied
by NuTone) FM antenna can be connected using RG-6 coax cable between FM antenna and FM connector on
TV/Monitor.
• Use RG-6 coax cable to connect TV antenna, or cable system to TV connector on TV/Monitor.
• Use supplied telephone cable to connect the phone jack to the TEL jack on TV/Monitor.
• Be certain a standard 120 VAC duplex outlet is located within reach of the power cord supplied with the TV/Monitor
(less than 6 ft).
AM Antenna Installation and Connection
The VSUC4RK is supplied with one AM radio antenna.
AM Loop Antenna
The loop antenna with 60" lead is designed to be mounted inside the
home. The loop antenna is installed after the cabinets have been
installed. Typically the loop antenna is mounted under the cabinet next to
the TV/Monitor, above the cabinet if the top of the cabinets is accessible,
or inside the cabinet. Experiment with the antenna orientation and place-
ment to optimize AM radio reception.
7