Nokia MEDIAMASTER 110S - Manual (Page 5)

GB 5
Connecting the Mediamaster
Front and Rear panel
A constant green light indicates that the
Mediamaster is turned ON.
A constant red light indicates standby mode.
The light flashes red when commands from
the remote control are received.
The light flashes green during software
updates.
Antenna
for connection of the
satellite antenna
DC in
for connecting the cable
from the external power
supply TV SCART socket *
for connection to the TV
Slot
for a Conax smart card
Digital audio
Digital audio output
(TOS-link optical
connecttion)
Connecting the Mediamaster
The box for your Mediamaster should contain the following items:
• the Mediamaster
• a remote control with 2 AAA batteries
• a SCART cable (fully connected; 1.0 m)
• an Introduction Guide
• a separate power supply
Preparing the remote control
• Remove the cover from the battery compartment at the bottom
of the remote control.
• Insert the 2 AAA (1.5 V) batteries as shown in the diagram,
taking care to observe the + and - markings indicated inside.
• Replace the cover.
* The TV SCART Socket
When you connect other devices to this socket, always use a fully
connected SCART cable like the one supplied. There are SCART
cables available that do not have all the pins connected,
which could reduce picture quality if you were to use them.
Power supply
Remote Control