Nokia MEDIAMASTER 110S - Manual (Page 8)

GB 8
First-time installation
Switching on for the first time
and getting started
• Plug in your Mediamaster and the "First-time installation" menu
appears.
• Press ok to continue.
• Select the desired menu language using the cursor up/down
button.
• This will also become the main language for audio and
subtitling.
• Press ok to continue.
Antenna/satellite selection
• Select the “One antenna/one LNB configuration” alternative if
you have a single antenna equipped with one LNB for receiving
signals.
• Select the “Multisatellite/DiSEqC switch configuration” alter-
native if you have one antenna with two or four LNBs or two
antennas with one or two LNBs each for receiving signals
from a combination of satellites. In these cases you will
also need a 2-way or a 4-way DiSEqC switch.
One antenna/one LNB configuration
Select this alternative if you have one (1) LNB mounted
on the antenna.
LNB type
Select the correct LNB for your configuration. The most common
values, including Universal LNB, can be selected using the cursor
left/right button.
LNB offset voltage
If the cable from the antenna is very long, the voltage at the LNB
could be too low to change the polarisation. You can increase the
voltage to the LNB by 0.5 V.
Satellite
Select one of the pre-programmed satellites.