Nokia MEDIAMASTER 110S - Manual (Page 7)

GB 7
Connecting the Mediamaster & First-time Installation
Conax smart card
The Mediamaster is equipped with a built-in decoder for the
Conax encryption system.
Insert a Conax smart card fully into the slot on the back of the
Mediamaster. The gold chip must face downwards and inwards.
Connecting a Hi-fi system
It is possible to connect a TOS link cable from the Digital audio
output on the Mediamaster to a Hi-fi system that is equipped
with the corresponding audio input.
• Also use the TOS link Digital audio output for connection
to an external Dolby digital/DTS decoder.
First-time installation general information
Once you have correctly connected the Mediamaster, you will also
have to perform a "First-time installation." During this procedure,
helpful information is displayed at the bottom of the menus.
The ok button always confirms a selection within these menus,
and pressing it will take you to the next step in the installation
process. However, sometimes more than one value has to be
entered in a menu. Make all the necessary changes first.
Then, confirm them all simultaneously by pressing ok.
• You can always go back to the previous menu by pressing back.
• Use the cursor up/down buttons to move upwards
and downwards from one line to another.
• Use the cursor left/right buttons to change settings.
• Use the number buttons on the remote control to enter numeric
values.