Napco Security Technologies GEM-K2AS - Manual (Page 29)

29
K E Y P AD M E S S AG E S
Arming attempted with zone in trouble. Faulted zones will scroll. Correct trouble to arm.
Arming attempted while the alarm is sounding. A valid user code will silence the sound
and clear this message.
Attempted to arm with Easy Arm and the alarm is sounding. The alarm wit not silence
without a valid user code.
Arming attempted with a system trouble present. To arm, press C and the system
troubles will disappear.
(With pulsing sounder). Trouble condition on a Day Zone (zone numbers will scroll).
Press
C to silence sounder. Note: Watch Mode must be active.
Alarm Condition, followed by zone number(s). "ALARM" and zones will display after sys-
tem is disarmed. Note zones, then press
C to clear keypad.
The alarm signal has been cancelled during the Abort Delay (before an alarm signal re-
port was sent to the central station). If cancelled after the alarm signal report was sent,
this message appears when the system receives an acknowledgment from the central
station of the cancellation of the alarm signal.
A C O N
DAY ZN
A C O N
ALARM
A C O N
CAN'T/
ARMZNF
A C O N
CAN'T/
ARMSIL
A C O N
CAN'T/
ARMSND
A C O N
CAN'T/
ARMRST
T R O U B L E
A C O N
CANCEL