Napco Security Technologies GEM-K2AS - Manual (Page 6)

6
AR M I N G AW AY : S E T T I N G T H E AL AR M W H E N L E AV I N G
Z O N E S F A U L T E D
0 2 B A C K D O O R
BYPA SSED B Y P A S S E D
BYPA SSED 0 2 B A C K D O O R
Arming the System
Note: The keypad will autoscroll messages that are longer than one line.
1 Check the keypad. The green STATUS light must be on in order to arm. If the
green light is off, “FAULT” will display in the window followed by the number of
each faulted zone. Note each problem zone and secure it by closing a window,
door, etc. When all zones are secure, the green STATUS light will turn on and the
window will display “READY”.
Bypass faulted zones. If you cannot locate or repair the problem yourself, call
for assistance. If you cannot get immediate help, bypass the problem zone(s)
from the system by pressing
B , then the zone number (or vice versa). Note:
Bypassed zones are unprotected. If armed with zones bypassed, be sure to have
the system checked as soon as possible.
2 Arm the system. Enter your code and press Q . The green STATUS light will
go off, the red ARMED light will turn on and the window will alternately display
“EXIT" and "XX SEC" (where “XX” represents the exit time remaining, in 10-
second steps). Note: If you enter an invalid code, the keypad will display “Wrong
Code”.
3 Leave the premises. Leave through the exit door before exit time expires.
A C O N
READY
A C O N
FAULT/
ZONE 02
B Y P A S S E D A C O N
READY
A C O N
EXIT/
XX SEC