NEC LT10 - Manual (Page 12)

-
nglish
Installation
Lens cap
On/Standby
1
2
Powering On the Projector
1. Remove the lens cap.n
2. Ensure that the power cord and signal cable are securely
connected.
3. Turn on the lamp by pressing “On/Standby” button on the
control panel. o
The startup screen will display for 20 seconds and the Power
indicator will flash green.
When the startup screen disappears, the Power indicator will
turn green.
4. Turn on your source (computer, notebook, video player ,
etc.). The projector will detect your source automatically.
™ If the screen displays “No Signal”, please make sure the signal
cables are securely connected.
™ If you connect multiple sources at the same time, use the “Source”
button on the remote control or control panel to switch between them.
Powering On/Off the Projector
™ Turn on the projector
first and then the
computer.