NEC MT 820 - Manual (Page 16)

This section describes how to set up your MultiSync MT1020/MT820 LCD
projector and how to connect video and audio sources.
Setting Up Your MultiSync MT1020/MT820
LCD Projector
Your MultiSync MT1020/MT820 LCD Projector is simple to set up and use.
But before you get started, you must first:
1. Determine the image size
2. Set up a screen or select a non-glossy white wall onto which you can project
your image.
Carrying The LCD Projector Always carry your LCD projector by the
handle. Ensure that the power cord and any other cables connecting to video
sources are disconnected before moving the projector. When moving the
projector or when it is not in use, cover the lens with the lens cap.
I N S T A L L A T I O N 2
Carrying handle
Pull out
Selecting A Location The further your LCD projector is from the screen or
wall, the larger the image. The minimum size the image can be is approxi-
mately 20" (0.5 m) measured diagonally when the projector is roughly 3 feet
(1.0 m) from the wall or screen. The largest the image can be is 300" (7.6 m)
when the projector is about 40.03 feet (12.2 m) from the wall or screen.
350
300
250
200
150
100
50
0
0.0 6.56 13.12 19.69 26.25 32.81 40.03 ft.
(2.0) (4.0) (6.0) (8.0) (10.0) (12.2) (m)
Projection Distance
Diagonal Image Size (inch)
Projection Distance and Image Size
300”
235”
WIDE
TELE
27”
20”
INSTALLATION
29
30
Width
Height
Screen size
(diagonal)
Projection distance
Push to release the
handle.
Push to retract