Nikon NP4100 - Manual (Page 26)

1. Introduction
11
I TEM L ABEL D ESCRIPTION S EE PAGE :
10. SC TRIGGER
When connected to the screen through a
commercially available cable, the screen de-
ploys automatically on start up of the
projector. The screen retracts when the pro-
jector is powered off (see notes below)
133
11. S-VIDEO
Connect a commercially available S-video
cable from a video device
35
12. POWER SWITCH Turn on/off the projector 38, 48
13. AC IN Connect the supplied power cable 37
14. L/MONO, R
Connect RCA audio cables (not supplied)
from the input device right and left channels.
This audio jack is shared with S-Video input.
—
15. VIDEO IN
Connect a composite video cable (not sup-
plied) from a video device to the yellow RCA
jack
35
16.
COMPONENT IN
(Y, Cb/Pb, Cr/Pr)
Connect a component video enabled device 34
17.
COMPUTER 2 IN
(R/Cr, G/Y, B/Cb,
H, V)
Connect RGBHV or Component signal from
computer or component video enabled device
31
18. COMPUTER 1 IN
Connect a VGA cable (not supplied) from a
computer
31
19. AUDIO IN (1)
Connect the audio cable (not supplied) from
the input device
—
20. LAN
Connect a LAN cable (not supplied) from a
computer
103
21. SERVICE
Connect the USB cable (not supplied) from a
computer. For service personnel only.
—
Note:
To use this feature, you must turn on the Screen Trigger function on OSD.
Screen controllers are supplied and supported by screen manufacturers.
Do not use this jack for anything other than intended use. Connecting the wired
remote control to the Trigger mini jack causes damage to the remote control.