NetComm HS1100 - Manual (Page 82)

HS1100 Wireless Hotspot Gateway User Manual
81
Rule Item: The rule selected.
Rule Name: The rule name can be changed here.
Enable this Rule: After checking this function, the rule will be enabled.
Action: There are two options, Block and Pass. Block. “Block” is to prevent packets from passing. “Pass” is
to permit packets passing.
Protocol: There are three protocols to select from, TCP, UDP and ICMP. Or choose ALL to use all three
protocols.
Source MAC Address: The MAC address of the source IP address. This is for specific MAC address filter.
Source/Destination Interface: There are five interfaces to choose from, ALL, WAN, Wireless, Public LAN
(LAN1/LAN2 by default) and Private LAN (LAN3/LAN4 by default).
Source/Destination IP: Enter the source and destination IP addresses.
Source/Destination Subnet Mask: Enter the source and destination subnet masks.
Source/Destination Start/End Port: Enter the range of source and destination ports.
y Specific Route Profile
Click the hyperlink of Setting for Specific Route Profile, the Specific Route Profile list will appear.
Profile Name: The profile name can be changed here.
IP Address: The destination IP address of the host or the network.
Subnet Netmask: Select a destination subnet netmask of the host or the network.
IP Address: The IP address of the next router to the destination.
Default: Check this option to apply the default value.