Nokia M1122 - Manual (Page 34)

E Copyright Nokia Networks Oy C33906001SE_00 4-3
4.2 Step-by-step installation procedure
splitter
Figure 4-1 M1122 with cables and splitter (T66270) connected
(Telephone and ADSL services)
1. Plug the mains power cord to a mains outlet.
2. Switch on M1122. The PWR indicator lights up. After a while, the
red STA indicator blinks and then remains unlit. M1122 is now
functional.
3. Connect the Ethernet cable between your PC’s 10Base-T
connector and the Ethernet connector on the M1122 back panel
(ETH-1, ETH-2, ETH-3, or ETH-4).
4. Switch on your PC. The indicator corresponding the Ethernet port
you connected your PC to becomes green when your PC has
started. This indicator blinks when there is traffic in the
corresponding Ethernet port.
5. Connect the ADSL line cable between the DSL connector on the
M1122 back panel and ADSL line wall socket. If you want to use
ADSL and telephone services simultaneously, connect the splitter
according to Figure 4-1. After a while, the DSL indicator starts
blinking. This indicates that the ADSL line is being established.
When the DSL indicator remains lit, the line is functional.
6. During normal operation PWR and DSL indicators are lit and the
Ethernet indicators of the active Ethernet ports blink or are lit
depending whether there is traffic or not. COL indicator may blink
occasionally during normal operation.