NEC PF32WT100 - Manual (Page 10)

11
BASIC INSTALLATION
Switching On TV Set
1)If stand-by indicator is red, then
the TV set is in stand-by mode.
You can switch on using the
remote control POWER button
(A1), the NUMBER 0….9 buttons
(A3), or PROGRAM UP (A6) /
DOWN (A21) buttons. The front
panel PROGRAM UP/DOWN
buttons can also be used.
Once on, the stand-by indicator turns
off and the picture appears on the
screen.
2) If stand-by indicator is not lit,
then the TV set is powered off.
You must press the TV set
front panel MAIN POWER
button.
If a picture does not appear,
then the stand-by indicator will
be lighted red. In this case,
use the remote control as
indicated in 1).
3) If stand-by indicator is flickering then
the TV set is in child-lock mode.
It is necessary to use the remote
control POWER button (A1),
NUMBER 0….9 buttons (A3), or
PROGRAM UP (A6) / DOWN (A21)
buttons. The Top panel PROGRAM
UP/DOWN buttons will not function.
Once on, the stand-by indicator turns
and the picture appears on the
screen.
SWITCHING OFF
TV SET
1)Pressing the remote control
POWER button (A1), you can
switch off to stand-by mode (low
power consumption mode) which
also allows quick restart by remote
control (see above: SWITCHING
ON TV SET).
Remark: If a broadcast signal is not present after 30 minutes, the TV set will be automatically turned to stand-by mode.
2)Pressing the TV set front panel MAIN
POWER button, you can completely
power off the TV set. In this case, you
must use the same front panel
POWER button to switch on again
(see above: SWITCHING ON TV
SET).
Automatic Tuning
ATSS = Automatic Tuning and Sorting System.
To start the ATSS function :
1) Press the MENU button (A19), then select the INSTALL menu by using Remote control CURSOR UP (A6), DOWN
(A21) buttons.
2) Press and hold the OK button (A18) to start the automatic tuning.
The ATSS function has started when the phase “Please Wait!” appears (in red characters) in the help instructions box,
below the install menu. when the ATSS function is finished, the stored programs are displayed on screen using Edit
menu presentation (to exit tuning before automatic tuning is finished, press the remote control MENU button (A19)).