NEC PF32WT100 - Manual (Page 13)

14
SOUND MENU
To Select Listening Mode
1. Press the menu button to select the SOUND and to be displayed on the
right appearance. By pressing the CURSOR LEFT (A7)/RIGHT (A20),
the following five modes change cyclically.
STEREO > SURROUND > CONCERT > JAZZ CLUB > CATHEDRAL
- STEREO
This mode operates differently according to input source.
If RF or AV sources are inputted, it is operated STEREO or MONO by
only R/L (RIGHT/LEFT) speakers.
If SPDIF source is inputted, it is operated down mixed Dolby Digital
sound by only R/L speakers. Other speakers are not supportable.
- SURROUND
This mode operates automatically according to input source
(Reference the table.)
- CONCERT/ JAZZ CLUB/ CATHEDRAL
You can select mode according to your preference. These modes add your
choice to SURROUND sound.
So, you can enjoy a stereophonic sound by selecting these modes.
-VOICE CLARITY:This feature gives you more correct and clean Pronunciations.
Especially, it is outstanding in speech program.
SOUND
LISTENING
VOICE CLARITY
SPEAKER SETUP
CHANNEL DELAY
AVL
SPDIF INPUT
SURROUND
OFF
OFF
NONE
POSITION ADJUST
EXIT MENU
Input source Listening Mode
Dolby Digital 2.0 CH Dolby Pro Logic II
SPDIF Dolby Digital Dolby Digital
Except Dolby Digital 2.0 CH
PCM Dolby Pro Logic II
AV / RF Mono or Stereo Dolby Pro Logic II
Remark: Dolby Digital 2.0 CH represents
which is coded R/L sound. DTS
source through SPDIF input is not
supportable.
To Set up Speakers.
Reference
L/R : Left(Right) speaker
Ls/Rs : Left (Right) surround speaker
C : Center speaker.
SUB : Sub Woofer speaker
1. Press the CURSOR UP(A6)/DOWN(A21) buttons to select the
speaker setup and Press the OK (A18) button. then It will be displayed
on the right appearance.
2. You can setup the speaker output. If all speakers are connectrd, then
turn on Ls/Rs. If Ls/Rs is off, the Ls and Rs level menu will be inactive.
3. TEST TONE feature can be selected by pressing CURSOR LEFT(A7)/
RIGHT (A20)buttons. After turning the test tone ON, user can adjust
the level of each speakers connected, using NOISE tone.Simply use
CURSOR UP(A6)/ DOWN (A21)to select the speakers, and then do
the level adjustment using CURSOR LEFT(A7)/ RIGHT (A20)buttons.
Remark: When adjusting the speaker level,it is a good way to use this
test tone.
4. You can adjust all speakers’ level. Red point of each bar represents
original speaker level. If you press the CURSOR LEFT (A7), the
selected speaker level is decreased. On the contrary, the speaker
level is increased.
SOUND
LISTENING
VOICE CLARITY
SPEAKER SETUP
CHANNEL DELAY
AVL
SPDIF INPUT
SURROUND
OFF
OFF
NONE
POSITION ADJUST
EXIT MENU
OK
SPEAKER SETUP
Ls / Rs
TEST TONE
L LEVEL
C LEVEL
R LEVEL
Ls LEVEL
Rs LEVEL
SUB LEVEL
OFF
OFF
POSITION ON / OFF
EXIT MENU