Roland KR-115 - Manual (Page 21)

21
Before You Start Playing
Before You
Start Playing
Connecting the Power Cord
1.
Connect the supplied power cord to the AC inlet jack.
2. Connect the pedal cord to the Pedal jack.
3.
Cramp the power cord and pedal cord with Cord
Cramp and screw at A (see the picture above).
4. Cramp the power cord and pedal cord with Cord
Cramp and screw at B, C and D (see the picture
above).
5. Plug the power cord into an AC outlet.
Connect the Pedal Cable
Insert the pedal cable into the Pedal connector on the
jack panel of the KR.
fig.00-01
Turning the Power On and Off
941
NOTE
Turn on power to your various devices in the order specified. By
turning on devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
To turn the power on, turn the [Volume] knob all the
way down, and then press the [Power] switch.
The power will turn on.
After a few seconds, you will be able to play the
keyboard to produce sound.
Use the [Volume] knob to adjust the volume.
942
NOTE
This unit is equipped with a protection circuit. A brief interval (a few
seconds) after power up is required before the unit will operate
normally.
fig.00-06.e
To turn the power off, turn the [Volume] knob all the
way to the left, and press the [Power] switch.
The power will be turned off.
945
* If you need to turn off the power completely, first turn off the
POWER switch, then unplug the power cord from the power
outlet. Refer to “Power Supply” (p. 6).
b
c
e
Screw
Screw
Cord Cramp
A
KR117
KR115
C
D
A
B
C
D
B
e b
e c
KR117
KR115
Power
Power
KR117_115_r_e.book 21 ページ ２００６年２月２７日 月曜日 午前１１時５５分