Roland Portable Recorded R-26 - Manual (Page 88)

Connecting to Your Computer via USB
88
2.
Touch the desired sampling rate .
SAMPLE RATE
44.1 kHz
48.0 kHz
88.2 kHz
96.0 kHz
3.
Touch <BACK> .
* The following screen will appear if you
change the sampling rate setting while
the R-26 is connected in audio interface
mode. Disconnect the USB cable from
the R-26, and then plug it back in again.
Connecting the R-26 to
Your Computer
1.
Start up your computer .
2.
Switch on the R-26’s power (p . 24) .
3.
Use the included USB cable to
connect the R-26 to your computer .
USB Connector
R-26 Computer
4.
Select the mode (only if you’ve
chosen “SELECTABLE”) .
If the USB CONNECTION (p. 81) is set to
“SELECTABLE,” a selection screen will
appear when you connect the R-26 to your
computer, allowing you to select either
storage mode or audio interface mode. For
this example, touch <AUDIO I/F>.