RCA WHP175 - Manual (Page 10)

10
OPERATION (continued)
6. After selecting a channel, use the fine tuning control, located on right
earphone to adjust the reception. The PLL function automatically
locks the three channels, providing you with top-quality audio
reception with no sound loss.
7. Adjust the volume using the volume control, also located on the
right earphone.
8. When you are through using the headphones, switch them off
using the POWER ON/OFF button, and place the audio source
on standby.
Note: To ensure that your headphones are charged and ready for
use at all times, place them in the recharging cradle/transmitter when
not in use.
alternate Installation Configuration
The accessories included with your headphone system include a jack
adapter for connecting the unit to a 6.35 mm headphone socket and
a Y cable. Normally, when a device is plugged into a headphone jack,
it automatically shuts off the speakers. If you want the speakers to
continue playing while you are using the headphone set, you can use
the Y adapter instead of the headphone jack. Use the supplied Y cable
to connect your headphones to the two (red and white) RCA jacks.
Connect the other end of the stereo audio cable to the AUDIO IN input
jack at the back of the recharging cradle/transmitter. This is especially
useful if, for example, your family is listening to music in one room
of your home and you want to listen to the same music in another
room. It is also beneficial in families where one person has a hearing
impairment. That person can use the headphones to listen to the
audio source, adjusting the volume as needed. This type of connection
also enables you to use your headphones more simply as you will
only need to switch on the audio source and switch on your
headphones to activate.