RCA WHP175 - Manual (Page 9)


CONNECTING THE RECHARGING CRADLE/
TRANSMITTER
Follow this quick setup guide to ensure trouble-free installation of your
headphones. To connect the recharging cradle/transmitter to the audio
source, follow these steps.
1. Plug the stereo audio cable into the headphone jack of your audio
source (e.g., stereo, TV, CD player, DVD, etc.). If your audio source
has two RCA output jacks in place of a headphone jack, use the
supplied Y cable to connect your headphones to the two (red and
white) RCA jacks.
2. Connect the other end of the stereo audio cable to the AUDIO IN
socket at the back of the recharging cradle/transmitter.
3. Connect the AC/DC main power adapter to the DC IN power
supply socket at the back of the recharging cradle/transmitter. Then,
connect the adapter to an electrical outlet.
Important: This power unit is intended to be correctly oriented in a
vertical or floor mount position.
OPERATION
Standard usage
1. Switch on the audio source (TV, DVD, CD player, etc.) to which the
recharging cradle/transmitter is connected. If your audio source is
a DVD or CD player, start a disc.
WaRNINg: The recharging cradle/transmitter has an automatic
function that switches it off if the audio input jack does not receive
an audio signal for approximately two minutes. If the volume on
the audio source is too low, the recharging cradle/transmitter also
switches off after two minutes. This feature was installed to comply
with current legislation that reduces the amount of radio emissions
in the environment. To ensure that this function is not accidentally
triggered, set the audio source volume at approximately 50 percent
capacity. Consult your component user’s manual for details on how
to set the volume for headphones/earphones.
2. The recharging cradle/transmitter is now ready to receive an audio
signal. The recharging cradle/transmitter is activated automatically
when receiving an audio signal from the audio source.
3. Check to make sure the power on indicator light on the front of the
recharging cradle/transmitter is lit, indicating that the unit is ready.
4. Push the POWER ON/OFF button, located on the right earphone.
The LED light turns on to indicate activation.
5. The recharging cradle/transmitter features three phase lock loops
(PLL) for radio frequency transmissions. Select one of these channels,
using the switch on the back of the recharging cradle/transmitter.