RCA WHP175 - Manual (Page 11)

11
TROUBLESHOOTING
Refer to this troubleshooting section if you encounter any difficulties in
setting up and using your headphones.
PROBLEM
No sound heard
through the
headphones
Poor sound quality
or interference
SOLUTION
A) Check that your audio source, recharging
cradle/transmitter and headphones are
connected, supplied properly and turned on.
B) Check to ensure that the rechargeable
batteries are installed in the headset
correctly and have been recharged properly.
C) Check to ensure the recharging cradle/
transmitter is running and the power
indicator light on the unit is lit.
D) Check that the audio source is delivering
a sufficient signal to the recharging cradle/
transmitter’s AUDIO IN input jack.
A) Check to ensure that the sound provided
by the audio source is loud enough and
of sufficient quality.
B) Check if the batteries in the headphones have
sufficient power. Recharge or replace them,
if necessary.
C) Check to see if you have selected the best
transmission channel (1, 2, or 3) to provide
the optimum signal reception. If necessary,
try another channel, remembering to fine-
tune the reception using the tuning control.
D) Check if the distance between the headphones
and the recharging cradle/
transmitter is within the operating range.
(The effective range of this device is up to
150 feet/45 meters from the cradle/
transmitter.)* Move closer to the recharging
cradle/transmitter to receive the sound.
E) Check that the audio source provides
stereo sound.
* Range may vary by environment.