RAD Data comm MBE10-1D User Manual
Page 25
MBE Family Installation and Operation Manual
Chapter 1 Introduction
Technical Specifications
1-11
Control
Interface
Type
V.24/RS-232
Connector
RJ-45
Data Rate
2.4 to 19.2 kbps, 8 bits, No Parity,
Automatic rate detection
LED
Indicators
POWER (green)
On when the unit is powered-up
READY (green)
On when packets can be transferred
MAIN
(green)
On when the unit is configured as local (applicable to
Bridge mode only)
REMOTE (green)
On when the unit is configured as remote (applicable to
Bridge mode only)
LAN TX (yellow)
On when a packet is being transmitted to the LAN
LAN RX (yellow)
On when a packet is being received from the LAN
LAN ERR (red)
On when LAN interface indicates an error
LINK TX* (yellow)
On when a packet is transmitted to link
Blinks (every 15 seconds) when a synchronous link is
connected and the link is open
LINK RX* (yellow)
On when a packet is being received from the link
Blinks (every 15 seconds) when a synchronous link is
connected and the link is open
LINK ERR* (red)
On when the serial link interface indicates an error
Blinks when the serial link interface indicates an error
Note: *Refers to both Link 1 and Link 2 for dual port models
Panel
Controls
Reset
Front panel
Power ON/OFF
Rear panel
Power Supply
Voltage
100–240 VAC (±10%)
Frequency
50/60 Hz
Power
10 VA Max
Order from: Cutter Networks
Ph:727-398-5252/Fax:727-397-9610
www.bestdatasource.com