Raymarine Compass Instrument ST40 - Manual (Page 28)

Chapter 3: Installation 19
SeaTalk connections
CAUTION
When instruments are connected to SeaTalk, ensure that the
power supply for the SeaTalk 12 V line is protected by a 5 A fuse
or circuit breaker.
5 A circuit breaker
Red (+ve) 12 V dc supply
(e.g. course
computer
or battery)
Uninsulated wire
(screen) -ve
D4827-2
Typical SeaTalk connections
SeaTalk bus SeaTalk bus
SeaTalk interface
kit
Power cable
Note:
A 5 A fuse can be used in place of
the circuit breaker, if preferred.
Fitting the instrument
Fit your ST40 instrument as shown in the following illustrations.
1
D4759-1
Cutting centre
TOP
Cut o
ut
shad
ed a
rea o
nly
Cut o
ut h
ole
57 m
m (2
.25 in
)
diam
eter
ST40
Instru
men
t Tem
plate
Remove template from handbook (immediately after index), apply to required location
and mark cutting centre.
161_2c03.p65 01/05/01, 16:51 19