Roland PC-70 - Manual (Page 12)

12
Powering Up
* Once the connections have been completed (p. 10), turn on power to your various devices in the order
specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to
speakers and other devices.
Power to the various devices should be turned on in the appropriate order. First, turn on the
units from which MIDI messages will originate (computer, PC-70). Next, turn on the sound
module, then the audio reproduction equipment. This unit’s
power switch [23] is located on
its rear panel.
Power off your system in the reverse order.
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is
required before the unit will operate normally.
Setting the MIDI Channel (MIDI Transmit Channel)
To control the sound module, set the MIDI channel the PC-70 will use to transmit on to the
same channel the module is using to receive on. If the sound module is multitimbral, set the
channel on the PC-70 so it matches the MIDI channel of the Part in the module that you wish
to control.
fig.MidiCh.e
[Procedure]
1. Press MIDI/SELECT [3] (LED will show “SEL”).
2. Select the MIDI channel by pressing one of the 16 keys in the MIDI channel section
[6] .
3. Press MIDI/SELECT [3] again to confirm your selection.
MIDI Channel