Roland PC-70 User Manual
Page 14
14
Changing Drum Sets in a GS Sound Module
The Drum Part (ch. 10) of a GS module does not respond to Bank Select messages. However,
if you try to send only a Program Change message from the PC-70, a Bank Select message
will end up being transmitted along with it anyway because the data for the last sound
specified will have been retained in memory. For this reason, you should always send a
value of 0 for Controller Numbers 00 and 32 first, then send the Program Number in order to
make sure you obtain the Drum Set you need.
[Procedure]
1.
Set the MIDI transmit channel to 10.
2.
Press
MIDI/SELECT [3]
(LED will show “SEL”).
3.
Press the
G#4 black key (CC 00) [15]
.
4.
Press the “0” key in the
NUMERIC ENTRY section [17]
.
5.
Press
ENTER [19]
.
6.
Press the
F#4 black key (CC 32) [14]
.
7.
Press the “0” key in the
NUMERIC ENTRY section [17]
.
8.
Press
ENTER [19]
.
9.
Press the
A#4 black key (PC) [16]
.
10.
Select the Program Number by pressing keys in the
NUMERIC ENTRY section [17]
.
11.
Press
ENTER [19]
.
12.
Press
MIDI/SELECT [3]
again to confirm your selection.
[Example]
How to select the sound of Variation No. 8, Instrument No. 3 (Piano 3w) on the SC-
8850:
1.
Set the MIDI transmit channel to match that of the desired Part in the module.
2.
Press
MIDI/SELECT [3]
(LED will show “SEL”).
3.
Press the
G#4 black key (CC 00) [15]
.
4.
Press the “8” key in the
NUMERIC ENTRY section [17]
.
5.
Press
ENTER [19]
.
6.
Press the
F#4 black key (CC 32) [14]
.
7.
Press the “4” key in the
NUMERIC ENTRY section [17]
.
8.
Press
ENTER [19]
.
9.
Press the
A#4 black key (PC) [16]
.
10. Press the “3” key in the
NUMERIC ENTRY section [17]
.
11. Press
ENTER [19]
.
12. Press
MIDI/SELECT [3]
again to confirm your selection.