Radio Shack ET-918 - Manual (Page 18)

18
If you still have problems, disconnect the phone. If other phones on the same line
work properly, the fault is in this phone or its installation. If you cannot find the prob-
lem, take your phone to your local RadioShack store for assistance.
Handset does not ring or receive a page. Lift the base’s antenna to a fully vertical posi-
tion.
Move the handset closer to the base.
Move the base away from other electrical de-
vices.
Return the handset to the base to recharge
the battery pack.
The handset stops working or works
poorly during a call. Move the handset closer to the base.
Lift the base’s antenna to a fully vertical posi-
tion.
If the base lost power while the handset was
off of it, the security access-protection code
might have changed. With the handset re-
moved from the base, restore power to the
base, then place the handset back on the
base. The CHARGE indicator lights, indicat-
ing that the code is set again.
Be sure the handset’s battery pack is
charged. (If the battery pack power is too low,
it does not have enough power to light the
TALK/BATT LOW indicator.)
Problem Suggestion
43-1088_90.fm Page 18 Tuesday, August 17, 1999 2:57 PM