Radio Shack ET-918 - Manual (Page 7)

7
3. Insert the supplied AC adapter’s
barrel plug into the DC IN 9V jack
on the back of the base.
4. Route the adapter’s cord through
the left side of the strain relief slot
on top of the base and through the
left slots at the bottom of the base.
5. Plug the short modular cord into
the wall plate jack, press the
excess cord into the slot in the
center of the base, then align the
base’s keyhole slots with the wall
plate studs and slide the base
downward to secure it.
Strain Relief
Slot
Slot for
Excess
Cord
6. Press and lift out the handset
holder, turn it over and rotate it
180°, then snap it back into place
so it holds the handset.
7. Plug the adapter into a standard
AC outlet. The POWER indicator
on the base lights.
8. Lift the base’s antenna to a verti-
cal position.
Mounting the Base Directly
on the Wall
For this mounting method, you need
two flat-head wood screws (not sup-
plied) with heads that fit into the key-
hole slots on the bottom of the base.
1. Drill two holes 3 15 /
16
inches apart. Then
thread a screw into
each hole, letting the
heads extend about
3 /
16
inch from the
wall.
3 /
16
3 15 /
16
43-1088_90.fm Page 7 Tuesday, August 17, 1999 2:57 PM