Runco VIDEOXTREME VX-8D - Manual (Page 57)

Installation
Runco VX-8d Installation/Operation Manual 41
PRE
L
IMINAR
Y
3.10
Installing and
Adjusting the
CineWide Anamorphic
Lens If you are installing a VX-8d/CineWide or VX-8d/CineWide with AutoScope, proceed as
follows to install and adjust the anamorphic lens.
Anamorphic Lens
Installation and
Adjustment The VX-8d Anamorphic lens mount kit consists of everything shown in Figure 3-20. Some
components shipped with your projector may differ slightly from what is shown in these
instructions. If any items are missing or damaged, please contact your Runco dealer or
Runco Customer Service at (800) 23-RUNCO.
Figure 3-20. Anamorphic Lens Mounting Assembly - Exploded View
It is extremely important that the primary lens is properly
adjusted before you install the anamorphic lens. Ensure that
the image from the primary lens is perfectly centered on the
screen.
Note
2
3
4
6
7
8
5
1
9
Pitch Adjustment Yoke for Lens
Height/Y Adjustment
T-Screw and Washer
(2x)
T-Screw and
Washer (2x)
Pitch Adjustment
Anamorphic Lens
Holder
1/4-20 Hex Bolt (2x)
and Washer (2x)
AutoScope Carriage Plate or
Fixed CineWide Base Plate
Yaw/X Adjustment
Lever (2x)
Lens Adapter Ring and
Mounting Screws (3x)
Pitch Adjustment
T-Nut (2x)
10 Anamorphic Lens
Set Screw