Rockford Fosgate X2 - Manual (Page 10)

10
O
PERATION
C
OLOR
O
PTIONS
Personalize your Type RF amplifier by
changing the top and corner plastics to
different colors. Available through our web
site or local retailer.
The corners can be changed by removing the screw
at the bottom, pull the old corner up and out, install
the new corner, and reinstall the screw.
The top plastic requires you to remove the cover
plate from the amplifier. Do this by removing the
four (4) 3/16" allen screws from each corner.
Remove the screw holding the top plastic in place,
pull the old top up and out, install the new top,
ensure the top fits into the notches at the back, and
reinstall the screw. Reinstall the cover plate and the
four (4) allen screws.
Allen
Screw
Screw
3. Press the Select or (right) key to enter into XOVER MODE. The screen
will display "XOVER MODE" at top and "SET: ALL PASS" with flashing
up and down arrows at the bottom.
4. For this example, using the (up) or (down) key, scroll through the
sub-menu until "HIGH PASS" shows next to "SET:" and then press
the Select key.
NOTE: If ALL PASS was set at this point and the Select key was pressed,
the DSP would have gone to the title display screen and no
further adjustment could be made to XOVER MODE.
5. After pressing the Select key, the display should now show "XOVER
FREQ" at top and "SET: 350" with flashing up and down arrows at the
bottom. 350 is the default number.
6. Press the (down) key to scroll down through the numbers until 80
shows next to "SET:". If you go too far, press the (up) key to scroll up
through the numbers. Pressing and holding a key for more than one
(1) second will quickly scroll through the selection.
7. When 80 has been set, press the Select key and the DSP will return to
the title screen. The amplifier crossover is now set to High Pass @
80Hz.
Use the same procedure to set the other features of the TYPE RF
amplifier to meet your application.
Save your settings
Once you have completed adjustments to the amplifier that fit your needs,
save these settings to one of the GLOBAL SAVE locations.
NOTE: If you need help or have
specific setting procedure
questions, contact Rockford
Technical Support.
MUTING THE AMPLIFIER
To mute the amplifier outputs, press
the (up) and (down) keys at the same
time. Press the (up) and (down) keys
again to un-mute. This will not
change any settings in memory.
5-6 7
3
4
4