Rockford Fosgate X2 - Manual (Page 12)

12
Specifications subject to change without notice
S
PECIFICATIONS
MODEL- Type RF 2-Channel X1 X2 X3
Continuous Power Rating (RMS) - Measured at 12.6 Battery Volts
4
Ω Load Per Channel
25 Watts x 2 50 Watts x 2 75 Watts x 2
2 Ω Load Per Channel 50 Watts x 2 100 Watts x 2 150 Watts x 2
4 Ω Load Bridged (mono) 100 Watts x 1 200 Watts x 1 300 Watts x 1
Dimensions:
Height 3.175" (8.07cm) 3.175" (8.07cm) 3.175" (8.07cm)
Width 11.6" (29.46cm) 11.6" (29.46cm) 11.6" (29.46cm)
Length 15.09" (38.33cm) 17.59" (44.68cm) 20.09" (51.03cm)
Battery Fuse Rating (Amp) 30A 50A 80A
(External to Amplifier) Not Supplied Not Supplied Not Supplied
Fuse Type AGU AGU AGU
Signal-to-Noise Ratio >93dB A-weighted
Crossover Slope 48dB/octave
Crossover Frequency All Pass/Low Pass/High Pass/Direct
Crossover Frequency variable from 50Hz to 350Hz
Frequency Response 20Hz to 20kHz ±0.5dB
Bandwidth 20Hz to 22kHz ±3dB
Damping Factor @ 4 Ω (at output connector ) >200
Slew Rate 30 Volts/ms
IM Distortion (IHF) <0.05%
Acceptable Signal Voltage Range Variable from 100mV to 6.5V (RCA Input)
Protection NOMAD - Internal analog-computer output protection
circuitry limits power in case of overload. Thermal
switch shuts down the amplifier in case of overheating.
Input Impedance 20k ohms
A
CCESSORIES
Connecting PUNCH Capacitors
Maintain the power you need to your Type RF Amplifier.
Color Options
Personalize your Type RF amplifier by changing the top and corner plastics to different colors.
Available through our web site or local retailer.
See our website for other accessories to help you get the most out of your system.
www.rockfordfosgate.com – password TYPERFUSA to access the Type RF page.