Renesas Emulation Pod for M16C/80 Group MCUs M30803T-RPD-E - Manual (Page 14)

( 12 / 74 )
IMPORTANT
Notes on Stack Area:
• With this product, a maximum 20 bytes of the user stack is consumed as work area.
• If the user stack does not have enough area, do not use areas which cannot be used as stack (SFR
area, RAM area which stores data, or ROM area) as work area. Using areas like this is a cause of
user program crashes and destabilized emulator control. Therefore, ensure the +20 byte maximum
capacity used by the user program as the user stack area.
• With this product, the interrupt stack pointer (ISP) is set to 0500h and used as stack area after the
reset is released.
Notes on Reset Vector Area:
• For a reset vector area, memory of the emulation pod is always selected regardless of the setting
of EMEM dialog. Therefore when setting the microprocessor mode, to use a ROM of the target
system etc. as an area including a reset vector area, set a reset vector using a dump window etc.
• The reset vector area can be changed only when a program is stopped. When a program is executed,
the area can not be changed.
Note on Debugging MCUs with RAM over 24 KB:
• This product has an MCU with 24 KB of RAM. Therefore, it cannot debug MCUs with more than
24 KB of RAM. Also, internally reserved areas (006400h - 007FFFh) cannot be used.
Note on Debugging M16C/80T Group MCUs:
• With this product, the M16C/80T Group MCUs cannot be debugged. Prepare the emulation pod
for the M16C/80T Group MCUs.