Renesas Emulation Pod for M16C/80 Group MCUs M30803T-RPD-E - Manual (Page 58)

( 56 / 74 )
Chapter 5. Specifications
5.1 Specifications
Table 5.1 lists the specifications of the M30803T-RPD-E.
Table 5.1 Specifications of the M30803T-RPD-E
* For M30802 and M30805, the FLX-144NSD (not included) is required.
PC4701
10KB RAM: M30800 (100-pin)
128KB ROM: M30802 (144-pin)*
24KB RAM: M30803 (100-pin)
256KB ROM: M30805 (144-pin)*
M30805SGP (two pieces)
Single-chip mode
Memory expansion mode
Microprocessor mode
(1) 256 KB for internal ROM of MCU
(Fixed FC0000h - FFFFFFh, maximum operating frequency: 20
MHz, 0 wait)
(2) 1.5 MB (changeable) for expansion area
(Possible to allocate by 256 KB or 1 MB, maximum operating
frequency: 20 MHz, 1 wait)
20 MHz (Operating voltage: 5.0 to 5.5 V, divide-by-1)
10 MHz (Operating voltage: 2.7 to 5.5 V, divide-by-1)
X
IN
-X
OUT
Internal oscillator circuit board (OSC-3)
Switchable to external oscillator input
X
CIN
-X
COUT
Internal oscillator circuit board (32.768 kHz fixed)
Switchable to external oscillator input
2.7 to 5.5 V
5 to 35
°
C (no dew)
-10 to 60
°
C (no dew)
Supplied from PC4701
For 144-pin 0.5-mm-pitch LQFP (144P6Q-A):
FLX-144NSD (not included)
For 100-pin 0.5-mm-pitch LQFP (100P6Q-A):
(1) M30800T-PTC (included) + 100LCC-QSD (not included)
(2) M30800T-PTC (included) + 100LCC-DMS (not included) +
FLX-100NSD (not included)
For 100-pin 0.65-mm-pitch QFP (100P6S-A):
(1) M30800T-PTC (included) + 100LCC-DMS (not included) +
DUMMY100S (not included)
(2) M30800T-PTC (included) + 100LCC-DMS (not included) +
DIRECT100S (not included)
(3) M30800T-PTC (included) + 100LCC-DMS (not included) +
FLX-100NRB (not included)
For 100-pin LCC socket:
M30800T-PTC (included)
• U.S. EMI standards (FCC part 15 Class A)
• CE marking (EN55022, EN50082-1)
Emulator
Applicable MCUs
Evaluation MCU
Usable modes
Emulation memory
Maximum operating frequency
Clock oscillator
Operating frequency
Operating temperature
Storage temperature
Power supply to emulation pod
Connection to target system
(see 3.6 "Connecting the Target
System" on page 36)
Overseas standards