Radio Shack 43-3905 - Manual (Page 13)

13
Surge Protection
Your telephone has built-in protection circuits to reduce the
risk of damage from surges in telephone line and power line
current. These protection circuits meet or exceed the FCC
requirements. However, lightning striking the telephone or
power lines can damage your telephone. Lightning damage is
not common. Nevertheless, if you live in an area that has severe
electrical storms, we suggest that you unplug your phone when
storms approach to reduce the possibility of damage.
FCC Information
FCC Part 15
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult your local RadioShack store or an experienced radio/TV technician for help.
If you cannot eliminate the interference, the FCC requires that you stop using your equipment. Changes or
modifications not expressly approved by RadioShack may cause interference and void the user’s authority
to operate the equipment.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
FCC Part 68 and ACTA
a) This phone complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the
bottom of this equipment is a label that contains, among other information, a product identifier in the
format US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.
b) The registration jack USOC for the equipment is RJ11C or RJ11W.
c) This equipment is designed to be connected to the telephone network or premises wiring using a
compatible modular jack which is Part 68 compliant. A compliant telephone cord and modular plug is
provided with this product. See installation instructions for details.
d) The REN is useful to determine the quantity of devices that may be connected to the telephone line.
Excessive RENs on the telephone line may result in the devices not ringing in response to a n incoming
call. In most, but not all areas, the sum of RENs of all devices should not exceed five (5). To be certain of
the number of devices that may be connected to a line, as determined by the total RENs, contact the local
telephone company.
e) If this phone causes harm to the telephone network, the telephone company will notify you in advance
that temporary discontinuance of service may be required. But if advance notice isn’t practical, the
telephone company will notify the customer will be notified as soon as possible. You will be advised of your
right to file a complaint with the FCC if you believe it is necessary.
f) Your telephone company may make changes in its facilities, equipment, operations, or procedures that
could affect the operation of your equipment. If they do, you will be given advance notice so as to give you
an opportunity to maintain uninterrupted service.