Zanussi ZGL 643 ITX - Manual (Page 20)

1
2
4
3
1
2
4
3
1 Burner cap
2 Burner crown
3 Thermocouple
4 Ignition candle
Warning! If the burner does not light after 15
seconds, release the control knob, turn it into off
position and try to light the burner again after minimum 1
minute.
Important! In the absence of electricity you can ignite the
burner without electrical device; in this case approach the
burner with a flame, push the relevant knob down and turn
it counter-clockwise to maximum gas release position.
If the burner accidentally goes out, turn the control
knob to the off position and try to light the burner
again after minimum 1 minute.
The spark generator can start automatically when
you switch on the mains, after installation or a pow-
er cut. It is normal.
Turning the burner off
To put the flame out, turn the knob to the symbol .
Warning! Always turn the flame down or switch it off
before you remove the pans of the burner.
Helpful hints and tips
Energy savings
• If possible, always put the lids on the pans.
• When the liquid starts to boil, turn down the flame to
barely simmer the liquid.
Warning! Use pots and pans with bottom applicable
to the dimension of burner.
Do not use cooking vessels on the hotplate that overlap its
edges.
Burner Diameters of cookware
Rapid / Triple
Crown
180 - 260 mm
Semi-rapid 120 - 220 mm
Auxiliary 80 - 180 mm
Warning! Pots must not enter the control zone.
Warning! Make sure pot handles do not protrude
over the front edge of the cooktop and that pots are
centrally positioned on the rings in order to achieve
maximum stability and to obtain lower gas consumption.
Do not place unstable or deformed pots on the rings to
prevent from spill and injury.
Warning! Flame diffuser are not recommended.
Information on acrylamides
Important! According to the newest scientific knowledge, if
you brown food (specially the one which contains starch),
acrylamides can pose a health risk. Thus, we recommend
that you cook at the lowest temperatures and do not brown
food too much.
Care and cleaning
Warning! Switch the appliance off and let it cool
down before you clean it. Disconnect the appliance
from the electrical supply, before carrying out any
cleaning or maintenance work.
Warning! For safety reasons, do not clean the
appliance with steam cleaners or high-pressure
cleaners.
20