Installing a module in the chassis, Control module, 1 installing a module in the chassis – RuggedCom RUGGEDBACKBONE RX5000 User Manual
Page 10: 2 control module, System. see, Section 2.2, “control module
Chapter 2
RuggedBackbone™ Modules
RuggedBackbone™ RX5000
Installation Guide
4
Installing A Module In The Chassis
Section 2.1
Installing A Module In The Chassis
To install a module in the the RuggedBackbone™ chassis, align the module guide ribs with the channels on the
chassis and push the module in as far as it will go. There is a detent position that must be pushed through to
properly seat the connectors; this is the added resistance from the grounding springs. When properly seated, the
module flange will rest on the main chassis frame. Tighten the thumbscrews using finger strength only.
NOTE
Serial line modules are hot-swappable, meaning they can be removed and installed while the device is
running.
When installing a serial line module while the device is running, make sure internal VLANs are
enabled. For more information about configuring VLANs, refer to the ROX User Guide for the RX5000.
Section 2.2
Control Module
The Control Module (CM) is the central processing unit of the RuggedBackbone™ chassis. The ROX operating
system running on the CM controls and coordinates the functions of all modules installed in the system. The
Control Module is installed in the CM slot of the chassis, as shown in