RuggedCom RUGGEDBACKBONE RX5000 - Manual (Page 34)

Chapter 4
Technical Specifications
RuggedBackbone™ RX5000
Installation Guide
28 Fiber Ethernet Port Specifications
Parameter Specification Notes
Cable-Type > Category 5 Shielded/Unshielded
Wiring Standard TIA/EIA T568A/B Auto-Crossover, Auto-Polarity
Max Distance 100 m
Connector RJ45
Isolation 1.5kV RMS 1-minute
Section 4.4
Fiber Ethernet Port Specifications
The following sections detail fiber optic specifications of ports that can be ordered with the modules on a
RuggedBackbone™ RX5000. The user determines the type of optics at time of ordering, and can determine the
modules installed on a particular unit by reading the factory data file via the ROX user interface. Section 4.4.1,
“Fast Ethernet (100Mbps) Optical Specifications” and Section 4.4.2, “Gigabit Ethernet (1Gbps) Optical
Specifications” list the specifications of the optical transceivers used in the fiber Ethernet modules available for
the RX5000. The specifications are organized by signaling speed and then by order code. Module order codes
are contained within each unit when it is assembled and configured at the factory. Consult the RuggedCom ROX
User Guide for help in obtaining the factory configuration data.
Section 4.4.1
Fast Ethernet (100Mbps) Optical Specifications
Table 11: Fast Ethernet (100Mbps) Optical Specifications
Order
Code
Mode
Connector
Type
Cable
Type
(µm)
Tx λ
(typ.)
(nm)
Tx min.
(dBm)
Tx max.
(dBm)
Rx
Sensitivity
(dBm)
Rx
Saturation
(dBm)
Distance
(typ.)
(km)
Power
Budget
(dB)
62.5/125 -19 12
FX01 MM ST
50/125
1300
-22.5
-14 -31 -14 2
8.5
62.5/125 -19 12
FX02 MM SC
50/125
1300
-22.5
-14 -31 -14 2
8.5
FX11 MM LC 62.5/125 1300 -19 -14 -32 -14 2 13
62.5/125 -19 12
FX03 MM MTRJ
50/125
1300
-22.5
-14 -31 -14 2
8.5
FX04 SM ST 9/125 1310 -15 -8 -32 -3 20 17
FX05 SM SC 9/125 1310 -15 -8 -31 -7 20 16
FX06 SM LC 9/125 1310 -15 -8 -34 -7 20 19
FX07 SM SC 9/125 1310 -5 0 -34 -3 50 29
FX08 SM LC 9/125 1310 -5 0 -35 3 50 30
FX09 SM SC 9/125 1310 0 5 -37 0 90 37