Roland TD-20 User Manual
Page 15
SMARTRIGGER USERS GUIDE
Version 1.4
2/10/2010
©2004 All Rights Reserved. http://www.smartrigger.com
o Aux Input HEAD = Ride Bell Sound
o Aux Input RIM = Ride Edge Sound (Same as #10 RIM)
Notes for using the Smartrigger CY-16R Dual Zone Ride Cymbal:
Use the optional Y cable on the module end of the ride’s stereo cable. Plug the black
TIP plug into the RIDE input and the orange RING plug into the AUX 1 input.
Settings for the Roland TD-9
Type
Sens
Thold Curve Rim
Gain
Scan ReTrg
Can.
Mask
Xtalk Mount
Splash
CY8
8-10
2
Linear
1.0
2.0
6
10
40
Cym
Crash
CY14C
8-10
2
Linear
0.8
1.6
6
10
40
Cym
China
CY14C
8-10
2
Linear
0.8
1.6
6
10
40
Cym
Ride
Bow
CY8
8-10
2
Linear
1.0
2.0
8
10
40
Cym
Ride
Bell
CY8
12-14
0
Linear
1.1
2.0
8
10
40
Cym
Hi Hat
CY-12H
8-10
2
Linear
1.0
2.0
6
10
40
Cym
Notes for using the Smartrigger CY-16RC3 Triple Zone Crash/Ride Cymbal:
Connect the cable marked RIDE to the cymbal’s bow trigger jack (left jack looking at the
bottom).
Connect a separate stereo cable (not one in the cable harness) from the bell trigger jack
to the AUX input on the side of your TD-9 module.
IMPORTANT!!! Make sure you have the two inputs set to trigger the appropriate sounds
for each kit
o Ride Input HEAD = Ride Bow Sound
o Ride Input RIM = Ride Edge Sound
o AUX Input HEAD = Ride Bell Sound
o AUX Input RIM = Ride Edge Sound (Same as Ride RIM input)
Notes for using the Smartrigger CY-16R Dual Zone Ride Cymbal:
Plug a cable into the RIDE input. A Ride sound should be assigned to the HEAD trigger
and a Bell sound should be assigned to RIM trigger.
Use the CY8 Trigger Type and increase the RIM GAIN to 5.0 and adjust from there.