Raritan Engineering toilet - Manual (Page 10)

10
PLUMBING
Intake Lines
Pressurized Freshwater Models
Install a shut off valve in intake line before water solenoid
valve.
1. Connect hose from shut off valve to inlet port of
water solenoid valve at the toilet.
NOTE: To avoid malfunction of water solenoid due to
debris in water, installation of Freshwater Strainer
(190601) is recommended.
Remote Sea Water Models
Intake pump fittings are interchangeable to allow more
flexibility during installation. Inlet ports are located on
either side of intake pump. Outlet port (to toilet bowl) is
at top of intake pump.
NOTE: To avoid poor pump performance installation
of strainer (163000) is recommended
1. Slide fitting clips to open position.
2. Select inlet port to be used.
3. Install appropriate fittings into inlet and outlet ports.
NOTE: The 90° fitting can be rotated 360°.
4. Install the plug fitting into unused inlet port.
IMPORTANT: Be sure not to install plug fitting
into outlet port! Damage to pump will occur!
5. Slide fitting clips back to closed position.
6. Connect hose from seacock to inlet port of optional
In-Line Strainer if installed. Use hose clamp
provided.
7. Connect hose from outlet port of In-Line Strainer to
inlet port of intake pump. Use hose clamp provided.
IMPORTANT: Double clamp all below waterline
hose connections!
8. Connect hose from outlet port of intake pump to
bowl elbow located on back of toilet bowl.
From
Seacock
To Intake
Pump
Arrow
Open
Closed
Plug
From
Strainer
Inlet Ports
Outlet Port To Bowl
Inlet
port
Discharge
port