Raritan Engineering toilet - Manual (Page 12)

12
D. WIRING
WARNING: Hazard of Shock and Fire
• Always use proper wire, wire connectors and
fuse/circuit breaker. See Specification
Chart.
• Secure wire properly.
• Do not connect appliances to toilet circuit.
• Make sure power is off before proceeding.
• Use proper wire terminals for all wire
connections.
1. Determine proper wire size by measuring distance
from:
• Power Source to push button to toilet motor
and back to power source.
• Remote pump units - also include distance
from power source for remote pump to
remote pump and back. Same wire gauge
must be used for both lower base and remote
pump.
2. Select proper wire and fuse/circuit breaker size
from Specifications on Installation page.
3. Install fuse/circuit breaker in positive line at source.
4. Wire control to the toilet and battery using one of
the following wiring diagrams.
WIRING
To start Electroscan from toilet control, run a wire
from “to EST “ to terminal marked “EXT TRIG”
inside Electroscan control module (black box).
To start Elegance equipped with Smart Switch from
Electroscan, connect “Head1” to “FROM EST “.
For Lectra/San MC, call Raritan Customer Service
ELECTROSCAN OPERATION
Smart Flush Control
Fig. 13
CUT
OUT